A、使用說明：1、用清洗劑噴濕約5次注射之塑料安機以下(4安機以下)。2、用手套或膠 袋混和。3、儲料后1至2分鐘，才把塑料射出（重復以下程序，勿連續射出）4、將料斗 清潔乾凈，加入轉色后所用新塑料，將之前余料射出后即可正常注塑。
B、特色：節省轉色時間及膠料、清潔炭漬及保護螺桿，使用方便。
C、注意：勿讓兒童取玩。如不慎入眼，應立即以清水沖洗。
警 告：使用前作小樣測試而作出肯定。內含壓力氣體，勿讓兒童玩耍，勿近火源使 用，勿擠壓與碰撞，不可曝曬或燃燒，存放在 40℃ 以下陰涼、通風乾燥處。 A, instructions for use: 1, with the cleaning agent sprayed wet about 5 times the injection of plastic less than the following (4 below the machine). 2, use gloves or plastic bags. 3, after 1 to 2 minutes, only the plastic injection (repeat the following procedures, not continuous injection) 4, the hopper clean, adding to the color after the new plastic, the remaining material will be injected before the normal injection molding.B, features: to save the color time and plastic materials, clean carbon stains and protection of the screw, easy to use.C, attention: do not let children play. In case of contact with eyes, please rinse with water immediately.
Warning: to make sure the sample test before use. Containing gas under pressure, do not let the child play, not near the fire source, do not squeeze and collision, not exposure or burning, stored in 40 DEG C cool, ventilated and dry place.

查看全部介紹